Project

General

Profile

Actions

Task #573

open

add SPI UART

Added by Andrew Kohlsmith about 12 years ago. Updated about 12 years ago.

Status:
New
Priority:
Normal
Target version:
Start date:
10/18/2014
Due date:
% Done:

0%

Estimated time:

Description

Just hedging bets here, add an NXP SC16IS750IBS SPI UART to the board just in case direct SPI isn't going to cut it

Actions #1

Updated by Andrew Kohlsmith about 12 years ago

When the ESP8266 is set up to boot from UART or from SD (i.e. not in slave mode) then that is probably a good time to also allow the SPI UART to use the CS line. I'll probably end up needing another CS line anyway.

Actions

Also available in: Atom PDF